AudioCodes MediaPack 114 Uživatelský manuál stáhnout pdf (Strana 331)

Version 5.6 331 November 2008

SIP User's Manual 7. IP Telephony Capabilities

Figure 7-5: Collecting Digits Mode

7.4.2.3 Ring Detection Timeout

The operation of Ring Detection Timeout depends on the following:

 No automatic dialing and Caller ID is enabled: if the second ring signal doesn’t arrive

for Ring Detection Timeout, the device doesn’t initiate a call to the IP.

 Automatic dialing is enabled: if the remote party doesn't answer the call, and the

ringing signal stops for Ring Detection Timeout, the FXO releases the IP call.

Ring Detection Timeout supports full ring cycle of ring on and ring off (from ring start to ring

start).

7.4.2.4 FXO Supplementary Services

The FXO supplementary services include the following:

 Hold / Transfer toward the Tel side: The ini file parameter LineTransferMode must

be set to 0 (default). If the FXO receives a hook-flash from the IP side (using out-of-

band or RFC 2833), the device sends the hook-flash to the Tel side by performing one

of the following:

• Performing a hook flash (i.e., on-hook and off-hook)

• Sending a hook-flash code (defined by the ini file parameter HookFlashCode)

The PBX may generate a dial tone that is sent to the IP, and the IP side may dial digits

of a new destination.

 Blind Transfer to the Tel side: A blind transfer is one in which the transferring phone

connects the caller to a destination line before ringback begins. The ini file parameter

LineTransferMode must be set to 1.

1 2 ... 326 327 328 329 330 331 332 333 334 335 336 ... 389 390

Žádné komentáře

AudioCodes MediaPack 114 Uživatelský manuál Strana 331