AudioCodes MediaPack 114 Uživatelský manuál stáhnout pdf (Strana 202)

SIP User's Manual 202 Document #: LTRT-65411

MediaPack Series

3.5.1.1.1 Configuring the SNMP Trap Destinations Table

The 'SNMP Trap Destinations' page allows you to configure up to five SNMP trap

managers.

¾ To configure the SNMP Trap Destinations table, take these 5 steps:

1. Access the 'Management Settings' page, as described in ''Configuring the

Management Settings'' on page 199.

2. In the 'SNMP Trap De

stinations' field, click the right-pointing arrow

button; the

'SNMP Trap Destinations' page appears.

Figure 3-93: SNMP Trap Destinations Page

3. Configure the SNMP trap managers parameters according to the table below.

4. Click the Submit button to save your changes.

5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.

Note: Only table row entries whose corresponding check boxes are selected are

applied when clicking Submit; otherwise, settings revert to their defaults.

Table 3-53: SNMP Trap Destinations Parameters Description

Parameter Description

SNMP Manager

[SNMPManagerIsUsed_x]

Determines the validity of the parameters (IP address and port

number) of the corresponding SNMP Manager used to receive

SNMP traps.

 [0] (Check box cleared) = Disabled (default)

 [1] (Check box selected) = Enabled

IP Address

[SNMPManagerTableIP_x]

IP address of the remote host used as an SNMP Manager. The

device sends SNMP traps to these IP addresses.

Enter the IP address in dotted-decimal notation, e.g., 108.10.1.255.

Trap Port

[SNMPManagerTrapPort_x]

Defines the port number of the remote SNMP Manager. The device

sends SNMP traps to these ports.

The valid SNMP trap port range is 100 to 4000. The default port is

162.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 389 390

Žádné komentáře

AudioCodes MediaPack 114 Uživatelský manuál Strana 202