AudioCodes MediaPack 114 Uživatelský manuál stáhnout pdf (Strana 162)

SIP User's Manual 162 Document #: LTRT-65411

MediaPack Series

3. Configure the Tel to IP Routing table according to the table below.

4. Click the Submit button to save your changes.

5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.

Table 3-41: T

el to IP Routing Table Parameters Description

Parameter Description

Tel to IP Routing Mode

[RouteModeTel2IP]

Determines whether to route Tel calls to IP before or after

manipulation of destination number.

 [0] Route calls before manipulation = Tel-to-IP calls are routed

before the number manipulation rules are applied (default).

 [1] Route calls after manipulation = Tel-to-IP calls are routed after

the number manipulation rules are applied.

Notes: Not applicable if outbound Proxy routing is used.

Src. Trunk Group ID

[PREFIX_SrcTrunkGroupID]

The source Hunt Group for Tel-to-IP calls.

The range is 1-99.

Notes:

 If this parameter is not required in the routing rule, leave the field

empty.

 To denote any Hunt Group, you can enter the asterisk (*) symbol.

Dest. Phone Prefix

[PREFIX_DestinationPrefix]

Represents a called telephone number prefix. The prefix can be 1 to

19 digits long. An asterisk (*) represents all numbers.

Source Phone Prefix

[PREFIX_SourcePrefix]

Represents a calling telephone number prefix. The prefix can be 1 to

19 digits long. An asterisk (*) represents all numbers.

All Tel calls matching all or any combination of the above routing rules are subsequently sent to the

destination IP address defined below.

Notes:

 For alternative routing, additional entries of the same prefixes can be configured.

 For notations representing multiple numbers, refer to ''Dialing Plan Notation'' on page 155.

Dest. IP Address

[PREFIX_DestAddress]

The destination IP address (in dotted decimal notation) to where

these calls must be sent. Domain names (e.g., domain.com) can be

used instead of IP addresses.

Notes:

 If you select a destination IP Group (in the 'Dest IP Group ID' field

below), then the IP address you define in this 'Dest IP Address'

field is not used for routing and therefore, not required.

 To discard outgoing IP calls of a specific Tel-to-IP routing rule,

enter 0.0.0.0. For example, if you want to prohibit dialing of

international calls, then in the 'Dest Phone Prefix' field, enter 00

and in the 'Dest IP Address' field, enter 0.0.0.0.

 For routing calls between phones connected to the device (i.e.,

local routing), enter the device's IP address. When the device's IP

address is unknown (e.g., when DHCP is used), enter the IP

address 127.0.0.1.

 When using domain names, you must enter a DNS server IP

address or alternatively, define these names in the 'Internal DNS

Table' (refer to ''Internal DNS Table'' on page 166).

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 389 390

Komentáře k této Příručce

Žádné komentáře

AudioCodes MediaPack 114 Uživatelský manuál Strana 162

Komentáře k této Příručce

Související produkty a manuály pro Brány / ovladače AudioCodes MediaPack 114