AudioCodes MediaPack 114 Uživatelský manuál stáhnout pdf (Strana 267)

Version 5.6 267 November 2008

SIP User's Manual 4. ini File Configuration

Parameter Description

EnableRport

Enables / disables the usage of the 'rport' parameter in the Via

header.

 [0] = Enabled.

 [1] = Disabled (default).

The device adds an 'rport' parameter to the Via header of each

outgoing SIP message. The first Proxy that receives this message

sets the 'rport' value of the response to the actual port from which

the request was received. This method is used, for example, to

enable the device to identify its port mapping outside a NAT.

If the Via doesn't include 'rport' tag, the destination port of the

response is taken from the host part of the Via header.

If the Via includes 'rport' tag without a port value, the destination

port of the response is the source port of the incoming request.

If the Via includes 'rport' tag with a port value (rport=1001), the

destination port of the response is the port indicated in the 'rport'

tag.

IsFaxUsed

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

T38UseRTPPort

Defines the port (with relation to RTP port) for sending and

receiving T.38 packets.

 [0] = Use the RTP port +2 to send / receive T.38 packets

(default).

 [1] = Use the same port as the RTP port to send / receive T.38

packets.

Notes:

 For this parameter to take effect, you must reset the device.

 When the device is configured to use V.152 to negotiate audio

and T.38 coders, the UDP port published in SDP for RTP and

for T38 must be different. Therefore, set the the parameter

T38UseRTPPort to 0.

DefaultReleaseCause

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

IPAlertTimeout

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

SIPPSessionExpires

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

SessionExpiresMethod

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

MINSE

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

SIPMaxRtx

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

SipT1Rtx

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

SipT2Rtx

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 389 390

Komentáře k této Příručce

Žádné komentáře

AudioCodes MediaPack 114 Uživatelský manuál Strana 267

Komentáře k této Příručce

Související produkty a manuály pro Brány / ovladače AudioCodes MediaPack 114