AudioCodes MP-204B Uživatelský manuál Strana 7
- Strana / 11
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
7
See Figure 6 below.
Figure 6 – With these settings any incoming call is routed to 10000.
Outgoing
A gateway may have more physical trunks than are being used at a site. When an outgoing call is being
made to the PSTN it is important that the gateway not choose a trunk that is not there or not in service.
Enable only those trunks that are actually in use.
If an operational trunk is busy, the gateway must ‘hunt’ for a free trunk to complete the call. Configure a
trunk group that specifies which trunks are to be used for outgoing calls and what the hunting algorithm
should be, for example, ascending or descending.
1. Go to Protocol Management -> Endpoint Phone Numbers.
2. Assign each trunk the same Hunt Group ID.
See Figure 7 below.
Figure 7 – The important thing here is the Hunt Group ID.
3. Go to Protocol Management -> Hunt Group Settings.
4. For the Hunt Group ID chosen select an appropriate Channel Select Mode.
Související produkty a manuály pro Brány / ovladače AudioCodes MP-204B
Brány / ovladače AudioCodes MP-11 Uživatelský manuál
(49 stránky)
(49 stránky)
Brány / ovladače AudioCodes Mediant Series Specifikace
(136 stránky)
(136 stránky)
Komentáře k této Příručce