AudioCodes MP-118 Instalační manuál Strana 1

Document #: LTRT-59811 March 2010 Installation Manual Version 6.0

Installation Manual 10 Document #: LTRT-59811 MediaPack Series Reader’s Notes

Version 6.0 11 March 2010 Installation Manual 1. Introduction 1 Introduction This manual provides you with step-by-step procedures for initial an

Installation Manual 12 Document #: LTRT-59811 MediaPack Series Reader’s Notes

Version 6.0 13 March 2010 Installation Manual 2. Installing the Device 2 Installing the Device This section describes the MP-11x (refer to &apos

Installation Manual 14 Document #: LTRT-59811 MediaPack Series 2.1.1.2 MP-11x Rear Panel The device's rear panel provides the ports for cabl

Version 6.0 15 March 2010 Installation Manual 2. Installing the Device 4. Ensure that in addition to the MP-11x unit, the package contains the f

Installation Manual 16 Document #: LTRT-59811 MediaPack Series 2.1.3.1 Desktop Mounting Attach the four (supplied) anti-slide bumpers to the base

Version 6.0 17 March 2010 Installation Manual 2. Installing the Device 3. Attach the shelf to the rack using four standard rack screws (not supp

Installation Manual 18 Document #: LTRT-59811 MediaPack Series 2.1.4.1 Connecting MP-11x to the Network Follow the procedure below for connecting

Version 6.0 19 March 2010 Installation Manual 2. Installing the Device 2.1.4.3 Cabling the FXS Lifeline The Lifeline provides a wired analog POT

Installation Manual 20 Document #: LTRT-59811 MediaPack Series ¾ To cable the combined MP-11x FXS/FXO Lifeline: 1. Connect a fax machine, modem,

Version 6.0 21 March 2010 Installation Manual 2. Installing the Device ¾ To connect MP-11x to a PC: 1. Connect the PS/2 connector (refer to the

Installation Manual 22 Document #: LTRT-59811 MediaPack Series 2.2 Installing MP-124 This subsection describes the MP-124 hardware installation.

Version 6.0 23 March 2010 Installation Manual 2. Installing the Device 2.2.1.2 MP-124 Rear Panel The device's rear panel (shown in the figu

Installation Manual 24 Document #: LTRT-59811 MediaPack Series 2.2.2 Unpacking and Checking Package Contents Follow the procedure below for unpac

Version 6.0 25 March 2010 Installation Manual 2. Installing the Device 2.2.3.2 19-inch Rack Mounting The MP-124 can be installed in a standard 1

Installation Manual 26 Document #: LTRT-59811 MediaPack Series ¾ To install the MP-124 in a 19-inch rack: 1. Remove the two screws located on on

Version 6.0 27 March 2010 Installation Manual 2. Installing the Device 2.2.4.1 Power Surge Protection and Grounding of MP-124 This section discu

Installation Manual 28 Document #: LTRT-59811 MediaPack Series The MP-124 chassis is equipped with a protective earthing screw. Ensure that you co

Version 6.0 29 March 2010 Installation Manual 2. Installing the Device 2.2.4.2 Connecting MP-124 to the Ethernet Network Follow the procedure be

Version 6.0 3 March 2010 Installation Manual Contents Table of Contents 1 Introduction ...

Installation Manual 30 Document #: LTRT-59811 MediaPack Series 2.2.4.3 Connecting MP-124 to FXS Interface The MP-124 interfaces with the analog t

Version 6.0 31 March 2010 Installation Manual 2. Installing the Device 4. Insert and fasten the male connector to the female 50-pin Telco connec

Installation Manual 32 Document #: LTRT-59811 MediaPack Series 2.2.4.4 Connecting MP-124 RS-232 Port to a PC Follow the procedure below to connec

Version 6.0 33 March 2010 Installation Manual 2. Installing the Device 2.2.4.5 Connecting MP-124 to Power The MP-124 can be powered either from

Installation Manual 34 Document #: LTRT-59811 MediaPack Series ¾ To connect MP-124 to a DC power supply: 1. Insert two 18 AWG wires into the sup

Version 6.0 35 March 2010 Installation Manual 3. Configuring the Device 3 Configuring the Device This section describes initial, basic setup conf

Installation Manual 36 Document #: LTRT-59811 MediaPack Series 3.1.1 Assigning an IP Address Using HTTP You can assign an IP address to the devic

Version 6.0 37 March 2010 Installation Manual 3. Configuring the Device 4. Change the device's IP address, by performing the following: a.

Installation Manual 38 Document #: LTRT-59811 MediaPack Series 8. In the ‘Gateway’ field, enter the IP address of the default gateway (if any). 9

Version 6.0 39 March 2010 Installation Manual 3. Configuring the Device b. Press the # key. c. Dial the new subnet mask (e.g., 255*255*0*0), an

Installation Manual 4 Document #: LTRT-59811 MediaPack Series 4 Monitoring the Device ...

Installation Manual 40 Document #: LTRT-59811 MediaPack Series c. Press the selected pattern code, and then press # to finish. 8. Press 1 to sav

Version 6.0 41 March 2010 Installation Manual 3. Configuring the Device 3.1.4 Assigning an IP Address Using the CLI You can assign an IP address

Installation Manual 42 Document #: LTRT-59811 MediaPack Series 3.2 Configuring Basic SIP Parameters Once you have completed the previous sections

Version 6.0 43 March 2010 Installation Manual 3. Configuring the Device 3.2.1 Enabling Channels and Configuring Call Routing (Example) This sect

Installation Manual 44 Document #: LTRT-59811 MediaPack Series The figure below shows an example of a configuration setup of two communicating FXS

Version 6.0 45 March 2010 Installation Manual 3. Configuring the Device 3.3 Saving and Resetting the Device To apply configuration changes to th

Installation Manual 46 Document #: LTRT-59811 MediaPack Series 3.4 Changing Login User Name and Password To prevent unauthorized access to the We

Version 6.0 47 March 2010 Installation Manual 3. Configuring the Device 3.5 Backing Up and Restoring Configuration You can save a copy/backup of

Installation Manual 48 Document #: LTRT-59811 MediaPack Series ¾ To load (or restore) the ini file: 1. Click the Browse button, navigate to the

Version 6.0 49 March 2010 Installation Manual 3. Configuring the Device 3.7 Upgrading the Device You can upgrade the device with the following f

Version 6.0 5 March 2010 Installation Manual Contents List of Figures Figure 1-1: Required Steps to Install the Device ...

Installation Manual 50 Document #: LTRT-59811 MediaPack Series ¾ To use the Software Upgrade Wizard: 1. Stop all traffic on the device (refer to

Version 6.0 51 March 2010 Installation Manual 3. Configuring the Device Note: At this stage, you can quit the Software Update Wizard, by click

Installation Manual 52 Document #: LTRT-59811 MediaPack Series 10. Click End Process to close the wizard, and then in the 'Enter Network Pa

Version 6.0 53 March 2010 Installation Manual 3. Configuring the Device ¾ To load an auxiliary file to the device: 1. Open the 'Load Auxil

Installation Manual 54 Document #: LTRT-59811 MediaPack Series Reader’s Notes

Version 6.0 55 March 2010 Installation Manual 4. Monitoring the Device 4 Monitoring the Device The operating status of the device can be monitore

Installation Manual 56 Document #: LTRT-59811 MediaPack Series Label Type Color State Function Data Packet Status Green Blinking Transmitting

Version 6.0 57 March 2010 Installation Manual 4. Monitoring the Device 4.2.2 Viewing Channel Status The 'Home' page displays channel p

Installation Manual Version 6.0 www.audiocodes.com

Installation Manual 6 Document #: LTRT-59811 MediaPack Series List of Tables Table 2-1: MP-11x Rear Panel Component Descriptions ...

Version 6.0 7 March 2010 Installation Manual Notices Notice This Installation Manual describes the hardware installation and quick configuration

Installation Manual 8 Document #: LTRT-59811 MediaPack Series Regulatory Information The Regulatory Information can be viewed at http://www.audioc

Version 6.0 9 March 2010 Installation Manual Notices Notes: • FXO (Foreign Exchange Office) is the interface replacing the analog telephone and