AudioCodes Mediant 1000 Instalační manuál Strana 19
- Strana / 76
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Version 6.0 19 February 2010
Installation Manual 2. Installing the Device
2.4.1 Connecting to Earth (Ground)
The device must be permanently connected to earth (ground), using an equipment-earthing
conductor.
Protective Earthing
The equipment is classified as Class I EN60950 and UL60950 and must be
earthed at all times.
¾ To earth the device:
1. Connect an electrically earthed strap of 16 AWG wire (minimum) to the chassis'
earthing screw (located on the rear panel), using the supplied washer.
2. Connect the other end of the strap to a protective earthing. This should be in
accordance with the regulations enforced in the country of installation.
Figure 2-6: Earthing the Device
- Installation Manual 1
- Table of Contents 3
- List of Figures 5
- List of Table 6
- Trademarks 7
- WEEE EU Directive 7
- Customer Support 7
- Related Documentation 8
- Caution Electrical Shock 8
- 1 Introduction 9
- Reader’s Notes 10
- 2 Installing the Device 11
- 2.1.2 Rear Panel 14
- 2.3 Mounting the Device 15
- 2.4 Cabling the Device 18
- Protective Earthing 19
- ¾ To connect the BRI ports: 23
- 2.4.10 Connecting to Power 28
- 2.5 Maintenance 29
- 2.5.2 Replacing Modules 30
- ¾ To replace I/O modules: 31
- 3 Configuring the Device 35
- To set a configuration URL: 39
- 3.3 Configuring PSTN Trunks 45
- 3.8 Upgrading the Device 51
- 4 Monitoring the Device 57
- 4.2 Web Interface 59
- Platform 61
- ¾ To install the CM module: 63
- To install the iPMX module: 64
- To install the HDMX module: 65
- 5.2.1 Requirements 68
- 5.2.2 Cabling 69
- 5.2.2.2 Cabling OSN2 70
- ¾ To cable OSN2: 70
- 5.2.3 Installing Linux 71
- 5.3.1 Cabling 73
(25 stránky)
Komentáře k této Příručce